

Related products
-
Quick view
4″ Low Profile Rest Short Post
$ 59.00 Add to cartDetails -
Quick view
Universal Lathe Stand
$ 850.00 Add to cartDetails -
Quick view
Tool Handles – Robust Collet Handle System
$ 69.00 – $ 159.00Whether you’re changing gouges or simply taking the handle off to make sharpening easier, the Robust Collet System makes it a quick job. Just a twist of the wrist. Robust designed the system around the popular ER series collets and each system comes equipped with four common sizes.View productsDetailsYou can buy the system with or without handles: The handles are hard maple with a polyurethane finish. The overall length for the ER32 handle is 20.5″ and the ER25 is 16″. If you want to make your own handle, buy the kit. The kit has all the metal pieces, including the collets, as well as basic instructions.
Collets in the ER 25 set: 1/4, 3/8, ½ & 5/8” Collets in the ER 32 set: 3/8, 1/2, 5/8 & 3/4" All of the ER series collets have an expansion range of a little more than 1/32" To accommodate gouges that are slightly oversize, the collets we provide are actually 1/32" larger than nominal. For instance, a 1/2" collet is actually 17/32". In regards to tools with square shanks, ER collets have eight segments. You'd want the corners of the square shank to register in them. If the four collets we provide don't work, you should be able to find one online that will at nominal cost. [su_row][su_column size="1/2"][/su_column][su_column size="1/2"][/su_column] [/su_row] Warranty Metal parts: 5 years. Wooden handle: 30 days. Please note: Wood is a natural material and while we inspect each piece visually for flaws and defects we cannot prevent breakage.
-
Quick view
For Most 15-16″ Lathes with 1″ Diameter Post
$ 49.00 – $ 119.0025MM POST WARNING: Certain Grizzly, Laguna and other imported lathes may use 25mm posts which are slightly smaller than 1”. THESE WILL NOT WORK. PLEASE MEASURE YOUR POSTS BEFORE ORDERING. FYI: 25mm = .984”, and 1” = 25.4mm. 25mm posts are available special order. NOTE: For the Oneway 1640, only the Low Profile style rests and 9” J-rest will fit. ANOTHER NOTE: Some of the 16" Grizzly and Harbor Freight lathes, notably the Grizzly G0462 have very short banjos. You'll want to order toolrests from the 18-25" page. Depending on your situation, you may need to trim the post down to length. A few minutes with a sharp, coarse hacksaw will fix you right up.