2 HP upgrade (220 volt)
$ 220.00
If you’re just working over the bed and plan to keep your work to less than 16” diameter, you’ll probably be OK with the 1.5HP. Also, if you only have access to the 110 volt electricity, you’ll be restricted to the 1.5HP. But if you have access to 220 and if you plan on taking the gap out and turning larger work, get the 2HP. It is expensive to make this change later on, as both the motor and the drive need to be swapped out.
Related products
-
Quick view#3 instead of #2 MT Tailstock
$ 75.00Add to cartDetails
If you have a lot of #3 MT accessories, you may want this option. Otherwise, stick with the stock #2 as almost all woodturning accessories are #2. -
Quick viewExtra Banjo
$ 445.00Add to cartDetails
Useful for long spindles that require a double posted toolrest (we make those special order). Also useful for steady rest work when you want a toolrest on each side of the steady rest. Toolrest not included. -
Quick viewTool Caddy
$ 59.00Add to cartDetails
A handy spot to store your centers, knock out rod and toolrests. If ordered with the lathe, it is used in lieu of the standard bed stop.
-
Quick viewVacuum Adapter
$ 109.00Add to cartDetails
A vacuum adapter is the rotary coupling needed to connect a vacuum hose to the lathe spindle. It simply slides into the handwheel end of the spindle and is held in place with two 0-rings. The threads for the fittings are standard ¼” NPT (National Pipe Thread), available online or at any hardware store. This is the only part of the vacuum system we sell.
