Cone Set For Live Center
$ 69.00
The Cone Set consists of the two aluminum pieces pictured here, but does not include the live center. The aluminum pieces are threaded ¾-10 and will fit other common live centers with the same threading. The large cone is 4” in diameter, and the smaller point is 1.5” diameter.
Related products
-
Quick viewFor Most 15-16″ Lathes with 1″ Diameter Post
$ 49.00 – $ 129.00View productsDetails
25MM POST WARNING: Certain Grizzly, Laguna and other imported lathes may use 25mm posts which are slightly smaller than 1”. THESE WILL NOT WORK. PLEASE MEASURE YOUR POSTS BEFORE ORDERING. FYI: 25mm = .984”, and 1” = 25.4mm. 25mm posts are available special order.
NOTE: For the Oneway 1640, only the Low Profile style rests and 9” J-rest will fit.
ANOTHER NOTE: Some of the 16" Grizzly and Harbor Freight lathes, notably the Grizzly G0462 have very short banjos. You'll want to order toolrests from the 18-25" page. Depending on your situation, you may need to trim the post down to length. A few minutes with a sharp, coarse hacksaw will fix you right up. -
Quick view4″ Low Profile Rest – Long Post
$ 59.00 Add to cartDetails -
Quick viewFor Most 10″ and 12″ Mini & Midi Lathes with 5/8″ or 16 mm Posts
$ 49.00 – $ 89.00View productsDetailsMost Mini and Midi lathes utilize toolrests with 5/8” diameter posts. These rests will fit common lathes in this category including all Jet Mini and Midi lathes, all Delta Mini and Midi Lathes, the General Maxi Lathe, Rikon Mini, Grizzly, Nova Comet and others that use a 5/8 or 16mm post.
NOTE: The Rikon and Laguna REVO Midi uses rests for 12” lathes with 1” posts.
NOTE: 3/4″ posts for the Oneway 1018 and Shopsmith are available special order. -
Quick view15” Comfort Rest Standard Post
$ 89.00Add to cartDetails
