

3 HP Upgrade (220 volt)
$ 330.00
Why get the 3 HP? It’s a little like buying a pickup with the big V8 for those times you pull your RV over the mountains. Because you will occasionally turn big wood with this lathe, you will appreciate the extra power. It’s also much cheaper to order this option with the lathe, as you are just paying the incremental cost between the 2HP and 3HP. If you order the 2HP and later want to change, both the motor and drive need to be replaced, and the retail value of these two items combined is greater than $1,000.
Related products
-
Quick view
S16 16” Bed Extension
$ 445.00The bed extension increases spindle capacity 16”. It is made from the same heavy materials as the lathe bed. You cannot use the Tilt-Away with the Bed Extension. Buy it with your lathe or add it later.
-
Quick view
#3 instead of #2 MT Tailstock
$ 75.00If you have a lot of #3 MT accessories, you may want this option. Otherwise, stick with the stock #2 as almost all woodturning accessories are #2.
-
Quick view
S16 Spindle Banjo (handy for small work)
$ 395.00The stock S16 Banjo is large and heavy so that you can use it over the gap without vibration. Some users find it clumsy for fine work, like a finial. In that case, you may want this smaller banjo that is still strong and sturdy, but shorter and lighter weight. Buy it with your lathe or add it later. Toolrest not included.
-
Quick view
S16 Caster Set
$ 445.00The casters on the S16 permanently mount to the legs. Toggle both ends down for moving and storing the lathe, and toggle them up when turning. There are three casters total. Two straight ones are mounted on the headstock end of the lathe and one swivel caster on the tailstock end. Because both ends toggle, you have ground clearance when moving and solid footing when turning.