S16 Caster Set
$ 395.00
The casters on the S16 permanently mount to the legs. Toggle both ends down for moving and storing the lathe, and toggle them up when turning. There are three casters total. Two straight ones are mounted on the headstock end of the lathe and one swivel caster on the tailstock end. Because both ends toggle, you have ground clearance when moving and solid footing when turning.
Related products
-
Quick viewRemote foot “OFF” switch
$ 129.00Add to cartDetails
The remote foot works in series with the regular stop button on the magnetic backed controller. Either one will stop the lathe spindle. It’s handy when you’re out of position or doing hollowing work when you have both hands on the tool and want to stop the lathe. -
Quick viewAuxiliary four outlet 110V E-box
$ 55.00Add to cartDetails
A rugged industrial power strip with its own built-in 15-amp circuit breaker. It can be positioned on the front (default) or back of the tailstock leg. It has a 12’ cord that must be plugged into a separate outlet. Handy for powering sanding tools and other powered accessories at the lathe. -
Quick viewTool Caddy
$ 49.00Add to cartDetails
A handy spot to store your centers and toolrests. Also doubles as a stop to prevent accidently sliding your headstock off the lathe bed. -
Quick view2 HP upgrade (220 volt)
$ 220.00Add to cartDetails
If you’re just working over the bed and plan to keep your work to less than 16” diameter, you’ll probably be OK with the 1.5HP. Also, if you only have access to the 110 volt electricity, you’ll be restricted to the 1.5HP. But if you have access to 220 and if you plan on taking the gap out and turning larger work, get the 2HP. It is expensive to make this change later on, as both the motor and the drive need to be swapped out.
